VDO SENSORS - FOR ENGINE MANAGEMENT V3.0 Manuale Utente Scaricare il pdf (Pagina 17)

PAGE

www.motec.com

APRIL 2011

ECU Accessories

Part No.

Ignition Expander 14001

AS Connector Ignition Expander (needs connector 68087) 14006

Traction Control Multiplexer 14002

AS Connector TC Multiplexer (needs connector 68087) 14005

Pierburg Boost Control Valve (includes connector) 58004

M4/M48 SUU Software Update Unit

63008

3 Port Boost Control Valve 58020

ECU Accessories include a mating connector unless otherwise stated

ECU Accessory Connectors

22 Pin Autosport IEX/TCMux Connector (AS612-35SN) 68087

DBW-4 Drive By Wire Module

Part No.

The DBW-4 works with M400/M600/M800/M880 ECUs running firmware V3.30T and later, and

provides 4 PID Controllers for drive by wire control, or generic PID control for servo motors. The

use of a DBW-4 does not require a DBW upgrade in your ECU. Mating connector not included

MoTeC DBW-4 14011

66 Pin Autosport DBW-4 Connector (AS618-35SN) 68089

Knock Monitoring and Control

Part No.

OKM Onboard Knock Module (for M800 P&P ECUs) 53115

Mitsubishi EVO X OKM Onboard Knock Module 53121

SKM Standalone Knock Module 53116

Knock Sensor Loom (for use with SKM) 61114

Knock Modules work with vehicle knock sensors to provide individual cylinder closed loop knock

control, allowing tuners to safely optimise high performance ignition maps. There is a standalone

module and a version specifically designed to mount onto an M800 Plug-In ECU. A competent

tuner needs to carry out a frequency analysis to determine the target frequency and knock module

settings. This is highly specialised work.

MoTeC Knock Modules will only be available through authorised dealers that have under-

taken specific training

DHB Dual Half Bridge

Part No.

DHB Dual Half Bridge (needs connectors 68050, 79121, and

79125 — see page 24)

41213

The DHB is a high current amplifier which allows low current auxiliary outputs to drive high current

loads such as motors. It contains two high current half bridge outputs, and connects to any auxil-

iary output of a MoTeC ECU or Dash Logger, which performs the control function, such as PWM

speed control, direction control or servo control. Mating connectors not included

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Commenti su questo manuale

Nessun commento

VDO SENSORS - FOR ENGINE MANAGEMENT V3.0 Manuale Utente Pagina 17

Commenti su questo manuale

Prodotti e manuali riguardandi Misurazione, test & controllo VDO SENSORS - FOR ENGINE MANAGEMENT V3.0